USING AEROSOL PAINT

Citadel spray paint is specially formulated to provide a tough, durable finish that is ideal for our metal and plastic models. When dry the surface will readily accept Citadel acrylic paints and washes.

1. Ensure the model to be sprayed is clean and any mold lines have been removed with a craft knife or file. Make sure you protect the area you're spraying with old newspaper or use the inside of a cardboard box. Spray in a well ventilated area, such as an open garage. Do not spray in a badly ventilated area, like a bedroom, lounge, or kitchen.

2. Place your models on an upturned box or a piece of cardboard so you can turn them and spray the backs without touching them. Temporarily fix the models on with double-backed sticky tape or bits of Blu-Tac so they don't fall off.

3. Shake the can vigorously for one minute before spraying and occasionally while in use.

4. Hold the can 20-30 centimetres from the models, spraying evenly across the surface of the models in short bursts.

5. For the best results, apply two thin coats rather than one heavy coat that may obscure the detail of the model. Allow the first coat to dry completely before adding the second.

6. If the surface bubbles or runs, you are spraying too close to the model or are applying too heavy a coat.

7. The undercoat is dry to the touch after 10-15 minutes and ready to paint on in 1 hour.

8. If the nozzle becomes clogged, twist a full turn. Under no circumstances stick a sharp object into the top of the can to clear blockage. Replace the nozzle with a gentle twisting motion, making sure the nozzle is facing away from you.

9. After use, turn the can upside down and spray until only gas emerges. This method prevents paint drying in the nozzle during storage.

Spraying models stuck on top of an upturned box